TM 10-3930-641-34-1
CRANKSHAFT SEALS REPLACEMENT (CONT)
(Sheet 5 of 7)
LOCATION/ITEM
ACTION
REMARKS
REAR SEAL
REMOVAL
1 Flywheel
Remove. (See flywheel removal/installation,
page 3-315.)
2. Crankshaft rear seal
Remove using puller (1) as shown at right.
NOTE
Rear wear sleeve must be replaced whenever
rear seal is removed.
3 Rear wear sleeve
a Install ring (from wear sleeve removal tool
kit) into the seal bore.
b. Install distorter (from wear sleeve removal
tool kit) between the ring and the wear
sleeve.
c. Turn distorter until its edge makes a crease
in the wear sleeve. Do this in two or more
places until the wear sleeve is loose.
d. Remove ring and wear sleeve.
TA0991 34
Go on to Sheet 6
3-335