TM 10-3930-641-34-1
CRANKSHAFT SEALS REPLACEMENT (CONT)
(Sheet 2 of 7)
LOCATION/ITEM
ACTION
REMARKS
4. Installer (5)
Put in position on locator.
5. Nut (6)
a. Coat base with clean engine oil.
b. Install on locator.
c. Tighten nut until installer has reached
end of its travel (when installer contacts
locator).
6 Locator, installer, nut
Remove.
7. Rear seal, wear sleeve
Check that position of each is correct. Distance
from rear face of crankshaft to rear edge of
wear sleeve must be 0.08 in. (2.03 mm). Dis-
tance from rear face of crankshaft to metal
face of seal must be 0.18 in. (4.57 mm).
End
3-337
