TM 10-3930-641-34-1
CRANKSHAFT SEALS REPLACEMENT (CONT)
(Sheet 6 of 7)
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION
1 Wear sleeve (1), crankshaft (2)
a Apply quick cure primer to wear sleeve
inside diameter and crankshaft outside
diameter.
b. After primer has set, apply retaining
compound to wear sleeve inside.
2. Locator (3), bolts
Install on crankshaft gear.
3. Rear seal (4), wear sleeve
a Coat lip of rear seal and outside diameter
of wear sleeve with clean engine oil.
b. Install front seal on wear sleeve as shown
at right.
NOTE
Make sure lip of seal is toward front of engine
and outside diameter bevel of wear sleeve is
toward outside of engine.
c. Put wear sleeve and front seal in position
on locator.
TA099135
Go on to Sheet 7
3-336