TM 10-3930-641-34-2
TORQUE CONVERTER INSTALLATION (CONT)
(Sheet 2 of 5)
LOCATION/ITEM
ACTION
REMARKS
1.
Torque converter
a. Install two 1/2-13NC eyebolts.
b. Fasten hoist and position torque
converter in the machine.
2.
Sleeve (5)
Make sure sleeve (5) is in alignment with tor-
que converter and flywheel housing before
torque converter is pushed into position in fly-
wheel housing.
3.
Torque converter
Push torque converter into flywheel housing.
4.
Cover
If teeth in flywheel are not in alignment with
teeth on housing for converter, then remove
cover (1) and turn shaft in converter until teeth
are in alignment and converter is in position.
5.
Flywheel housing
Install 11 capscrews that hold torque converter
to flywheel housing.
6.
Sleeve (5)
Install lock, capscrew, and lockwasher to hold
sleeve (5) in place.
7.
Tube assembly (3)
Put tube assembly (3) in position and install
capscrews that hold it at engine cooler.
8. Clamp (2)
Install.
9. Hose assembly (4)
Connect to torque converter.
TA099235
See TM 10-3930-641-20.
Go on to Sheet 3
4-13