TM 10-3930-641-34-2
TRANSMISSION CONTROL LOCK INSTALLATION (CONT)
(Sheet 2 0f 4)
LOCATION/ITEM
ACTION
REMARKS
1.
Transmission control lock (2)
a
Position on transmission.
b. Make sure rail in control lock engages
direction selector valve spool in
transmission hydraulic controls.
c.
Secure with capscrews.
2.
Wires (1)
Connect to switch on transmission control
lock.
CAUTION
a. Make sure direction selector valve spool in
transmission hydraulic controls moves freely
after transmission control lock is installed.
b. If valve spool does not move freely, remove
cover over transmission hydraulic controls.
c.
Loosen four capscrews that hold trans-
mission hydraulic controls in position.
d. Move valve group until direction selector
valve spool is free to move with the rail in
transmission control lock. Tighten the
valve group capscrews to a torque of
32-38 lb. ft. (44-52 N-m).
TA099381
Go on to Sheet 3
4-214
