TM 10-3930-641-34-2
REAR DIFFERENTIAL, BEVEL GEAR AND FRONT SUPPORT REMOVAL (CONT)
(Sheet 3 of 4)
LOCATION/ITEM
ACTION
REMARKS
5. Front support (2)
a. Attach to floor jack.
b. Place in position on differential as shown.
c. Install four capscrews (4) and nuts that
secure it.
NOTE
Tighten capscrews to a torque of 750-900 lb.
ft. (1007 to 2118 N-m).
6. Two junction blocks (3)
Connect to main frame on machine.
7. Tube assembly
Connect to grease fitting on support.
8. Drive shaft (5) and capscrews
Install shaft (5) and capscrews that hold it.
TA099411
Go on to Sheet 4
4-269
