TM 10-3930-641-34-2
DIFFERENTIAL AND BEVEL DISASSEMBLY (CONT)
(Sheet 5 of 7)
LOCATION/ITEM
ACTION
REMARKS
8. Lip type seal (34)
Remove from retainer.
9. Nut (39), lock (40), and washer (26)
Remove.
10. Housing (22)
Place on wood blocks.
11. Pinion shaft (18)
Using suitable press, remove from housing.
12. Bearing cone (24) and two bearing
Remove from housing.
cups (25)
13. Bearing cone (19), bearing cup (20)
Remove from pinion shaft.
14. Differential and bevel gear
Position on repair stand as shown.
15. Lock wire (10)
Remove.
16. Bearing caps (15)
a. Mark with scribe or grease pencil to
insure correct installation later.
NOTE
Bearing caps must be installed in exact
same location.
b. Remove.
TA099415
Go on to Sheet 6
4-275
