TM 10-3930-641-34-2
DIFFERENTIAL AND BEVEL GEAR ADJUSTMENT (CONT)
(Sheet 2 of 7)
LOCATION/ITEM
ACTION
REMARKS
1.
Pinion (6)
a. Install in housing (5) complete with
b. Install washer (4), lock and locknut (3).
c.
Tighten locknut until play of pinion is
approximately .012 in. (0.30 mm).
2.
Yoke assembly (1)
Install against locknut (3).
3.
Retainer and capscrew (2)
Install and torque to 230 to 300 lb. ft.
(315 to 405 N-m).
4.
Bevel pinion shaft (6)
a. Check end play again.NOTE
b. With yoke, retainer, and capscrew (2)
If end play is not correct, remove yoke assembly and
installed end play is .002 to .005 in.
adjust nut (3). Then repeat steps 2 thru 4.
(0.05 to 0.13 mm).
5.
Differential
Assemble with teeth of the ring gear toward
the TOP. (As shown in illustration).
Go on to Sheet 3
4-290
