TM 10-3930-675-10-2
PREPARATION FOR TRANSPORT - CONTINUED
0007 00
PLACING CAB IN TRANSPORT POSITION - CONTINUED
2.
Return Cab to Operational Position.
a. Run RTCH engine at idle.
b. Push auxiliary pump switch on instrument panel inside cab to start auxiliary pump.
c. Remove two retaining pins and ladder.
d. Open door of remote hydraulic control compartment.
e. Release cab by removing two retaining pins and pins from cab.
f. Pull side movement lever to move cab free of frame lock.
g. Pull cab lift/lower lever until cab is fully raised.
h. Push cab side movement lever until cab has moved all the way to center position.
i. Push cab lift/lower lever to lower cab transport lift.
LOCKING PINS LEVER
CAB SIDE MOVEMENT
LEVER
FOLDING BOOM
SUPPORT LEVER
CAB
LIFT/LOWER
LEVER
BOGIE WHEEL
PRESSURE VALVE
BOGIE WHEELS
LEVER
374M-0011
NOTE
Cab side movement lever may need to be operated to move cab slightly side to side, to enable
installation of pins.
Pins should be installed from the rear. Install rear pin first.
j. Lock cab in operational position by installing two pins and retaining pins to cab subframe.
k. Close and latch door of remote hydraulic control compartment.
l. Push auxiliary pump switch on instrument panel inside cab to turn pump OFF.
WARNING
DO NOT stand between the tires and the fenders when installing retaining pins. Failure to follow this
warning could result in injury or death.
m.If removed, install retaining pins in left and right boom support locking pin extensions.
n. Install handrail with two retaining pins.
0007 00-6