Error Code 1322 - Injector Circuit Failure -cont

Error Code 1322 - Injector Circuit Failure -cont - TM-10-3930-675-20-1_146

Table 8. Error Code 1323 - Injector Circuit Failure Troubleshooting Procedures

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
120

TM 10-3930-675-20-1 0007 00-29 ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED 0007 00 Table 7. Error Code 1322 - Injector Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1322 - Injector Circuit Failure - Continued a. Measure resistance from pin 1 (or A) on solenoid connector to engine block ground. Resistance should be greater than 100k ohms. If resistance is not as specified, notify SRA to replace internal actuator harness. b. Measure resistance from pin 2 (or B) on solenoid connector to engine block ground. Resistance should be greater than 100k ohms. If resistance is not as specified, notify SRA to replace internal actuator harness. 11.Place ignition switch to OFF position and, with rocker arm cover removed, disconnect no. 1 injector solenoid from internal actuator harness. 12.Measure resistance from post to post on solenoid. Resistance should be 0.5-1.5 ohms. a. If resistance is as specified, replace engine ECU (WP 0078 00). b. If resistance is not as specified, notify DS Maintenance to replace injector. >100K OHMS

Privacy Statement
Press Release
Contact