Error Code 1322 - Injector Circuit Failure -cont

Error Code 1322 - Injector Circuit Failure -cont - TM-10-3930-675-20-1_144

Error Code 1322 - Injector Circuit Failure -cont - TM-10-3930-675-20-1_146

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
118

TM 10-3930-675-20-1 0007 00-27 ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED 0007 00 Table 7. Error Code 1322 - Injector Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1322 - Injector Circuit Failure - Continued b. Measure resistance from 15-pin connector pin 2 (or B) to each injector pigtail nut that connects the no. 1 injector (resistance to one of these nuts must be within specifications). Resistance should be less than 10 ohms. If resistance is not as specified, notify SRA to replace internal actuator harness. 8. Place ignition switch to OFF position and disconnect internal actuator harness from injector solenoid connector and disconnect injector solenoid wires from solenoid. a. Measure resistance from pin A (or 1) of injector solenoid connector to injector wire pigtail nut. Resistance should be less than 10 ohms. a. If resistance is as specified, notify SRA to replace internal actuator harness. b. If resistance is not as specified, replace injector solenoid wires. b. Measure resistance from pin B (or 2) of injector solenoid connector to injector wire pigtail nut. Resistance should be less than 10 ohms. a. If resistance is as specified, notify SRA to replace internal actuator harness. b. If resistance is not as specified, replace injector solenoid wires. <10 OHMS

Privacy Statement
Press Release
Contact