TM 10-3930-675-20-1
0007 00-23
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0007 00
Table 7. Error Code 1322 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1322 - Injector Circuit Failure -
Continued
b. Check actuator harness and
ECU connector for dirt or
moisture in or on connector
and for missing or damaged
connector seals.
Remove dirt and moisture from
connector. Replace missing or
damaged connector seals (WP
0111 00).
2. Place ignition switch to OFF
position
and
disconnect
actuator harness from engine
ECU and 15-pin connector at
front of engine below rocker
arm cover. Install jumper wire
from pin 1 to pin 2 at 15-pin
connector, actuator harness
side.
3. Measure resistance from
actuator harness connector
pin 9 to actuator harness
connector pin 10. Resistance
should be less than 10 ohms.
a. If resistance is not as
specified, repair or replace
connectors (WP 0111 00).
b. If engine harness requires
replacement, notify SRA.
<10 OHMS
