TM 10-3930-675-20-1
0007 00-25
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0007 00
Table 7. Error Code 1322 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1322 - Injector Circuit Failure -
Continued
d. Measure resistance from
actuator harness connector
pin 10 to all pins in sensor
harness
connector.
Resistance
should
be
greater than 100k ohms.
a. If resistance is not as
specified, repair or replace
connectors (WP 0111 00).
b. If engine harness requires
replacement, notify SRA.
5. Place ignition switch to OFF
position
and
disconnect
actuator
harness
15-pin
connector at front of engine
below rocker arm cover.
Disconnect actuator harness
connector from engine ECU.
a. Measure resistance from
actuator harness connector
pin 9 to engine block
ground. Resistance should
be greater than 100k ohms.
a. If resistance is not as
specified, repair or replace
connectors (WP 0111 00).
b. If engine harness requires
replacement, notify SRA.
b. Measure resistance from
actuator harness connector
pin 10 to engine block
ground. Resistance should
be greater than 100k ohms.
a. If resistance is not as
specified, repair or replace
connectors (WP 0111 00).
b. If engine harness requires
replacement, notify SRA.
>100K OHMS
