Error Code 1227 - Sensor Voltage Supply Failure - Continued

Error Code 1227 - Sensor Voltage Supply Failure - Continued - TM-10-3930-675-20-1_301

Error Code 1227 - Sensor Voltage Supply Failure - Continued - TM-10-3930-675-20-1_303

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
269

TM 10-3930-675-20-1 0017 00-10 ENGINE ELECTRONIC CONTROL UNIT (ECU) TROUBLESHOOTING - CONTINUED 0017 00 Table 2. Error Code 1227 - Sensor Voltage Supply Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1227 - Sensor Voltage Supply Failure - Continued 6. Place ignition switch to OFF position and disconnect actuator harness connector from engine ECU. a. Inspect engine ECU and actuator harness connector for dirty, corroded, bent, broken, pushed back, and extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check engine ECU and actuator harness connector for dirt or moisture in or on connector and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 7. Place ignition switch to OFF position and disconnect sensor harness from engine ECU. a. Measure resistance from actuator harness pin 19 to all other pins in actuator harness. Resistance should be greater than 100k ohms. If engine harness requires replacement, notify SRA. >100K OHMS USE TEST LEAD KIT P/N 3822758

Privacy Statement
Press Release
Contact