TM 10-3930-675-20-1
0019 00-1
ENGINE OIL PRESSURE SENSOR TROUBLESHOOTING
0019 00
THIS WORK PACKAGE COVERS
Error Code 1135 - Oil Pressure Sensor Circuit Failure
Error Code 1141 - Oil Pressure Sensor Circuit Failure
Error Code 1143 - Oil Pressure Sensor Circuit Failure
Error Code 1415 - Oil Pressure Sensor Circuit Failure
Error Code 1435 - Oil Pressure Sensor Circuit Failure
INITIAL SETUP
References
TM 10-3930-675-10
Tools and Special Tools
Cable, breakout (Item 46, WP 0204 00)
Test lead, female (Item 48, WP 0204 00)
Test lead, male (Item 51, WP 0204 00)
NOTE
•
Refer to WP 0004 00 for additional troubleshooting guidance, information, and illustrations
that locate critical components.
•
Refer also to illustration at end of work package for component location.
Table 1. Error Code 1135 - Oil Pressure Sensor Circuit Failure Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1135 - Oil Pressure Sensor Circuit
Failure
1. Ensure that ignition switch is
in OFF position. Disconnect
engine harness from oil
pressure/temperature sensor
(WP 0093 00).
a. Inspect engine harness and
oil
pressure/temperature
sensor connectors for dirty,
corroded, bent, broken, and
pushed back or extended
pins.
Clean and repair connector(s) as
required (WP 0111 00).
b. Check engine harness and
oil
pressure/temperature
sensor for dirt or moisture
in or on connectors and for
missing
or
damaged
connector seals.
Remove dirt and moisture from
connector. Replace missing or
damaged connector seals (WP
0111 00).
