Error Code 1135 - Oil Pressure Sensor Circuit Failure - Continued

Error Code 1135 - Oil Pressure Sensor Circuit Failure - Continued - TM-10-3930-675-20-1_331

Error Code 1135 - Oil Pressure Sensor Circuit Failure - Continued - TM-10-3930-675-20-1_333

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
299

TM 10-3930-675-20-1 0019 00-4 ENGINE OIL PRESSURE SENSOR TROUBLESHOOTING - CONTINUED 0019 00 Table 1. Error Code 1135 - Oil Pressure Sensor Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1135 - Oil Pressure Sensor Circuit Failure - Continued 7. Measure supply voltage from pin C (or YELLOW) to pin B (or BLACK) of breakout cable. Voltage should be 0.50-1.40V. If voltage is not as specified, proceed with the following steps. 8. Ensure that ignition switch is in OFF position. Disconnect sensor harness from engine ECU. a. Inspect sensor harness and engine ECU connectors for dirty, corroded, bent, broken, and pushed back or extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check sensor harness and engine ECU for dirt or moisture in or on connectors and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 0.50-1.40V

Privacy Statement
Press Release
Contact