Table 2. Error Code 1141 - Oil Pressure Sensor Circuit Failure Troubleshooting Procedures.

Error Code 1135 - Oil Pressure Sensor Circuit Failure - Continued - TM-10-3930-675-20-1_334

Table 2. Error Code 1141 - Oil Pressure Sensor Circuit Failure Troubleshooting Procedures - Continued.

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
302

TM 10-3930-675-20-1 0019 00-7 ENGINE OIL PRESSURE SENSOR TROUBLESHOOTING - CONTINUED 0019 00 Table 2. Error Code 1141 - Oil Pressure Sensor Circuit Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1141 - Oil Pressure Sensor Circuit Failure 1. Ensure that ignition switch is in OFF position. Disconnect engine harness from oil pressure/temperature sensor (WP 0093 00). a. Inspect engine harness and oil pressure/temperature sensor connectors for dirty, corroded, bent, broken, and pushed back or extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check engine harness and oil pressure/temperature sensor for dirt or moisture in or on the connectors and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 2. Install breakout cable between sensor and engine harness connector. Place ignition switch in ON position. 3. Measure supply voltage from pin A (or RED) to pin B (or BLACK) of breakout cable. Voltage should be 4.75- 5.25V. If voltage is not as specified, proceed with the following steps. 4.75-5.25V

Privacy Statement
Press Release
Contact