Error Code 1122 - Intake Manifold Pressure Sensor Circuit Failure - Cont

Error Code 1122 - Intake Manifold Pressure Sensor Circuit Failure - Cont - TM-10-3930-675-20-1_392

Table 2. Error Code 1123 - Intake Manifold Pressure Sensor Circuit Failure Troubleshooting Procedures. - TM-10-3930-675-20-1_394

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
357

TM 10-3930-675-20-1 0022 00-7 ENGINE PRESSURE SENSOR TROUBLESHOOTING - CONTINUED 0022 00 Table 1. Error Code 1122 - Intake Manifold Pressure Sensor Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1122 - Intake Manifold Pressure Sensor Circuit Failure - Continued 11.Place ignition switch to OFF position and disconnect sensor harness connector from engine ECU. a. Measure resistance from pin 39 to pin 40 at sensor port of ECU. a. If resistance is less than 100k ohms, replace intake manifold pressure sensor (WP 0093 00). b. If resistance is greater than 100k ohms, replace engine ECU (WP 0078 00). b. Measure resistance from pin 39 of ECU sensor port to engine block ground. If resistance is greater than 100k ohms, replace engine ECU (WP 0078 00). 39 TO 40 39 TO GND <100K OHMS <100K OHMS USE TEST LEAD KIT P/N 3822917

Privacy Statement
Press Release
Contact