Table 2. Error Code 1123 - Intake Manifold Pressure Sensor Circuit Failure Troubleshooting Procedures.

Error Code 1122 - Intake Manifold Pressure Sensor Circuit Failure - Cont - TM-10-3930-675-20-1_393

Error Code 1123 - Intake Manifold Pressure Sensor Circuit Failure - Cont - TM-10-3930-675-20-1_395

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
358

TM 10-3930-675-20-1 0022 00-8 ENGINE PRESSURE SENSOR TROUBLESHOOTING - CONTINUED 0022 00 Table 2. Error Code 1123 - Intake Manifold Pressure Sensor Circuit Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1123 - Intake Manifold Pressure Sensor Circuit Failure 1. Ensure that ignition switch is in OFF position. Disconnect engine harness from intake manifold pressure sensor (WP 0093 00). 2. Inspect engine harness and sensor connector for dirty, corroded, bent, broken, pushed back, and extended pins. Clean and repair connector(s) as required (WP 0111 00). 3. Check engine harness and sensor connector for dirt or moisture in or on connector and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 4. Install breakout cable. Place ignition switch in ON position. Check intake manifold pressure sensor supply voltage. Check voltage between lead A and B of breakout cable. Voltage should be 4.75-5.25V. If voltage is not as specified, proceed. A B C 4.75-5.25V

Privacy Statement
Press Release
Contact