TM 10-3930-675-20-2
0074 00-9
TOPHANDLER PROXIMITY SWITCHES REPLACEMENT - CONTINUED
0074 00
SPREADER BEAM PROXIMITY SWITCH INSTALLATION - CONTINUED
6.
Loosely install proximity switch (17) to proximity switch plate (20) with two jamnuts (18).
CAUTION
Overtightening jamnuts will damage proximity switch threads.
7.
Place proximity switch (17) in same position as measured during removal and tighten two jamnuts (18) to 177 lb-in (20
Nm).
NOTE
Clearance between sensor end of proximity switch and flat rod below should be 5 mm (0.20 in).
8.
Install proximity switch (17) and proximity switch plate (20) to spreader beam (19) with two washers (16) and screws
(15).
9.
Install new tiedown straps.
END OF WORK PACKAGE
15,16
17
18
19
20