TM 10-3930-675-20-2
0085 00-2
DIRECTIONAL AND SIDE MARKER LIGHT MAINTENANCE - CONTINUED
0085 00
DIRECTIONAL LIGHT BULB AND LED REPLACEMENT - CONTINUED
2.
Remove two bulbs (4 and 5) from lamp holder (6).
3.
To remove LED (7), pull outward on LED panel until panel just separates from black plastic section of connector.
4.
Grasp black plastic and push in and rotate connector slightly counterclockwise and remove LED (7) from socket.
5.
To install LED (7), grasp black plastic section of connector and insert connector into socket. Push in and rotate slightly
clockwise.
6.
Push LED (7) panel over black plastic until fully seated.
7.
Install two new bulbs (4 and 5) to lamp holder (6).
8.
Install lens assembly (2) to light housing (3) and tighten five screws (1).
6
5
4
7
1
2
3
