TM 10-3930-675-20-20098 00-2BOOM ANGLE SENSOR REPLACEMENT - CONTINUED0098 00REMOVAL - CONTINUED4.Loosen four screws (11) and remove cover (10) from junction box (12), located on right side of boom. Inspect rubberseal in groove of cover. Replace only if damaged.5.Loosen cable nut (15) and slide cable nut, grommet (16), and bushing (17) back on cable (14) of boom angle sensor (4).CAUTIONTo avoid damage to junction box, a fine-tipped jeweler’s screwdriver should be used when disconnectingwires. DO NOT use a punch.NOTETag wires for installation.6.Using a jeweler’s screwdriver, disconnect three wires of cable (14) from terminal blocks (13) of junction box (12).NOTERemove tiedown straps as needed. Discard tiedown straps.7.Remove boom angle sensor (4) with cable (14) from vehicle.101112
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
