TM 10-3930-675-20-2
0132 00-2
STEERING SYSTEM HYDRAULIC HOSES AND FITTINGS REPLACEMENT - CONTINUED
0132 00
REMOVAL
1.
Close hydraulic reservoir ball valve (25) (refer to foldout, FO-3).
2.
Using illustration (refer to foldout, FO-3) as a guide, remove damaged hose(s) or fitting(s). Cap or plug openings.
NOTE
Note position of tiedown straps and clamps to aid in installation.
3.
Remove tiedown strap(s) and clamp(s) (if applicable). Discard tiedown straps.
4.
Discard o-ring(s) removed.
INSTALLATION
NOTE
Refer to General Maintenance Instructions (WP 0194 00) for complete instructions on connecting hydraulic
hoses and applying proper torque.
1.
Lubricate and install new o-ring(s).
2.
Remove caps/plugs and install and tighten hose(s) or fitting(s).
3.
Install clamp(s) and new tiedown strap(s) (if applicable) in same position as noted during removal.
4.
Open hydraulic reservoir ball valve (25).
5.
Check oil level in hydraulic reservoir (LO 10-3930-675-12).
6.
Start engine (TM 10-3930-675-10), operate steering, and check for leaks.
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0183 00).
END OF WORK PACKAGE
