TM 10-3930-675-20-2
0142 00-8
CAB TRANSPORT LIFT MAINTENANCE - CONTINUED
0142 00
CAB TRANSPORT LIFT STRUCTURE REMOVAL - CONTINUED
4.
Remove four screws (12), washers (13), and plate (11) from bottom of transport lift brackets (9).
5.
Remove screw (14), three washers (15), and cotter pin (16) holding bottom of cab lifting cylinders (3) to transport lift
brackets (9). Discard cotter pins.
NOTE
Hydraulic hoses are to remain connected to cab lifting cylinders. Do NOT attempt to loosen or remove.
6.
Raise lifting cylinders (3) from transport lift brackets (9) and set aside.
WARNING
•
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep
clear of heavy parts supported only by lifting device. Failure to follow this warning may result in death
or injury to personnel.
•
Lifting device must have a 2000 lb (908 kg) capacity to lift cab transport lift brackets. Failure to follow
this warning may result in death or injury to personnel.
7.
Using a nylon sling and suitable lifting device, remove eight screws (10), 16 washers (17), and two transport lift brack-
ets (9) from vehicle.
9
11
12,13
14,15
16
