TM 10-3930-675-24-1
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0008 00
Table 3. Error Code 1313 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1313 - Injector Circuit Failure - 4. Place ignition switch in OFF
Continued.
position
and
disconnect
internal actuator harness from
15-pin connector and from no.
3 injector solenoid.
a. Measure resistance from 15- a. If resistance is not as specified,
pin connector pin 5 to all
repair or replace connectors
(WP 0113 00).
other pins in connector.
Resistance should be greater b. If internal actuator harness
requires replacement, notify
than 100k Ohms.
SRA.
b. Measure resistance from 15- a. If resistance is not as specified,
pin connector pin 6 to all
repair or replace connectors
(WP 0113 00).
other pins in connector.
Resistance should be greater b. If internal actuator harness
requires replacement, notify
than 100k Ohms.
SRA.
5. Place ignition switch in OFF
position and, with rocker arm
cover removed, disconnect
internal actuator harness from
injector solenoid.
6. Measure resistance from a. If resistance is as specified,
replace engine ECU (WP 0079
injector solenoid pin A to pin
00).
B. Resistance should be 0.5 to
b. If resistance is not as specified,
1.5 Ohms.
replace injector (WP 0215 00).
7. Place ignition switch in OFF
position and, with rocker arm
cover removed, disconnect
internal actuator harness from
injector solenoid and remove
injector solenoid wires from
solenoid.
8. Measure resistance from post If resistance is not as specified,
to post on solenoid. Resistance replace injector (WP 0215 00).
should be 0.5 to 1.5 Ohms.
0008 00-11
