TM 10-3930-675-24-1
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0008 00
WARNING
Injector solenoids receive high voltage when engine is operating. To avoid personal injury or death
from electrical shock, do not wear jewelry or damp clothing, and do not touch injector solenoids or
solenoid wires when engine is operating.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1332 - Injector Circuit Failure.
1. Place ignition switch in OFF
position
and
disconnect
actuator harness from engine
ECU.
a. Inspect actuator harness and Clean and repair connector(s) as
ECU connector for dirty, required (WP 0113 00).
corroded, bent, broken,
pushed back, and extended
pins.
b. Check actuator harness and
Remove dirt and moisture from
ECU connector for dirt or
connector. Replace missing or
damaged connector seals (WP
moisture in or on the
0113 00).
connector and for missing or
damaged connector seals.
2. Place ignition switch in OFF
position
and
disconnect
actuator harness from engine
ECU and 15-pin connector at
front of engine below rocker
arm cover. Install jumper wire
from pin 7 to pin 8 at 15-pin
connector, actuator harness
side.
3. Measure resistance from a. If resistance is not as specified,
actuator harness connector pin
repair or replace connectors
(WP 0113 00).
26 to pin 36. Resistance should
b. If engine harness requires
be less than 10 Ohms.
replacement, notify SRA.
0008 00-62
