TM 10-3930-675-24-1
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0008 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1332 - Injector Circuit Failure -
b. Check internal actuator
Remove dirt and moisture from
Continued.
harness
and
injector
connector. Replace missing or
damaged connector seals (WWP
solenoid connector for dirt
0113 00).
or moisture in or on
connector and for missing or
damaged connector seals.
7. Place ignition switch in OFF
position and, with rocker arm
cover removed, disconnect
actuator harness from 15-pin
connector
and
injector
solenoid wires from no. 4
injector solenoid.
a. Measure resistance from 15- a. If resistance is not as specified,
pin connector pin 1 (or A) to
repair or replace connectors
(WP 0113 00).
each injector pigtail nut that
connects the no. 1 injector b. If internal actuator harness
requires replacement, notify
(resistance to one of these
SRA.
nuts must be within
specifications). Resistance
should be less than 10 Ohms.
b. Measure resistance from 15- If resistance is not as specified,
pin connector pin 2 (or B) to notify SRA to replace internal
each injector pigtail nut that actuator harness.
connects the no. 1 injector
(resistance to one of these
nuts must be within
specifications). Resistance
should be less than 10 Ohms.
0008 00-66
