TM 10-3930-675-24-1
ENGINE TPS AND IDLE VALIDATION SWITCH TROUBLESHOOTING - CONTINUED
0009 00
Table 3. Error Code 1431 - Voltage Detected at Both Idle Validation
Signal Circuits Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1431 - Voltage Detected at Both Idle 4.
Check resistance on
the loose If
resistance is
not as
specified,
Validation Signal Circuits - Continued.
part of connector X23 between continue with step 5.
pins 6 and 9. Resistance should
be <125 Ohms with the pedal
released. Check resistance
between 7 and 9. Resistance
should be <125 Ohms with the
11).
part of connector X23 between continue with step 6.
pins 6 and 7 while depressing
and releasing the pedal. There
00-11).
6. Check for resistance. Remove a. If resistance is not as specified,
the kick panel from in front of
replace accelerator pedal
the steering column to access
assembly (WP 0062 00).
the X690 connector on the b. Repair or replace damaged
accelerator
pedal
wiring
connector (WP 0113 00).
harness.
0009 00-14