TM 10-3930-675-24-1
BOOM LIFTING/LOWERING TROUBLESHOOTING - CONTINUED
0040 00
Table 8. Error Code 158 - Lift Cylinder Boom Down Valve, Component Failure Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 158 - Lift Cylinder Boom Down 1. Enter "DIAG SERVO" 9(13) a. If no "OUTPUT" mA values
Valve, Component Failure.
in the diagnostic menu and
display, perform
activate the boom lifting
troubleshooting steps for
function. LIFT "OUTPUT"
ERROR CODE 126.
and "INPUT" should have mA b. If no "INPUT" mA values
values during lifting function.
display, continue with step 2.
CAUTION
Uncontrolled function may occur with this error code.
DIAG SERVO
9(13)
2. Check voltage at X158 a. If voltage (16 to 24V) is found,
OUTPUT/INPUT
LIFT
0mA
0mA
between pin 3 and pin 4 with
disconnect X158 and check
LOWER
0mA
0mA
the resistance on the loose part
8). Should be 0V with the
of X158 between pin 3 and pin
joystick in the neutral position
4. Resistance should be 23 to
and 6 to 16V during the
25 Ohms. Check continuity of
lowering function.
each pin to ground.
b. If no voltage (6 to 16V) is
found, disconnect ECU (790)
connector 2 and check
c. Repair or replace damaged
shorted wires or connectors
(WP 0113 00).
d. Replace damaged ECU (790)
(WP 0080 00).
3. Move the cab to the transport a. If resistance (23 to 25 Ohms)
position (TM 10-3930-675-
is not as specified or shorted to
10). Remove the thin cover
ground, replace servo control
plate just in front of the cab
valve (WP 0250 00).
hose tray to gain access to the b. If specified resistance is
servo
Check
found, check continuity of
resistance of 6004 solenoid.
wires 1583 and 1584 and
Should be 23 to 25 Ohms.
ground.
c. Notify Ssutainment
Maintenance to replace
damaged or open harness.
d. Replace ECU (790) (WP 0080
00).
0040 00-8