TM 10-3930-675-24-2
ENGINE SENSORS REPLACEMENT - CONTINUED
0094 00
ENGINE POSITION SENSOR REMOVAL
1.
Disconnect connector (9) of engine position sensor (8) from connector (10) of engine wiring harness.
2.
Remove engine position sensor (8) and O-ring seal (7) from engine front cover (6). Discard O-ring seal.
7
8
6
9
10
ENGINE POSITION SENSOR INSTALLATION
NOTE
Ensure sensor is free of debris and is not chipped, cracked, or damaged.
1.
Install new O-ring seal (7) on engine position sensor (8).
2.
Install engine position sensor (8) on engine front cover (6). Tighten sensor to 216 lb-in. (24 Nm).
NOTE
Ensure locking tab on connector snaps in place.
3.
Connect engine wiring harness connector (10) to connector (9) of engine position sensor (8).
4.
0094 00-3