TM 10-3930-675-24-2
BATTERY CABLES REPLACEMENT - CONTINUED
0110 00
CLEANING AND INSPECTION
1.
Clean batteries and battery posts with a wire brush. Wipe clean with rags.
2.
Inspect for corrosion or other damage.
3.
Apply a protective coating of grease to battery posts.
INSTALLATION
1.
Connect two POSITIVE battery cables (11) to master battery switch (WP 0111 00).
2.
Connect POSITIVE battery cables (11) to two of four batteries (15).
3.
At end of two POSITIVE battery cables (11), raise plastic cap (12) and tighten screw (14) and nut (13) on battery cable
clamp.
4.
Install two battery cables (10) on four batteries (15).
5.
At ends of two battery cables (10), raise plastic cap (7) and tighten screw (9) and nut (8) on battery cable clamp.
6.
Connect four NEGATIVE cables (4) to side of battery compartment (1) with washer (6) and locknut (5).
7.
Connect NEGATIVE battery cables (19) to two of four batteries (15).
8.
At end of two NEGATIVE battery cables (19), raise plastic cap (18) and tighten screw (17) and nut (16) on battery cable
clamp.
8,9
10
7
11
19
12
13,14
10
15
18
16,17
0110 00-4
