TM 10-3930-675-24-2
CAB TRANSPORT LIFT MAINTENANCE - CONTINUED
0138 00
CAB ADJUSTMENT: TRANSPORT POSITION - CONTINUED
8.
Tap right rear transport receptacle (35) in place around frame pin (36). Keep U-shaped receptacle slot level, and center
pin in slot.
9.
Slowly move cab back to operational position to access adjusted receptacle (35).
10.
Tighten receptacle bolts (37) and nuts (39) to 180 lb-ft (244 Nm).
11.
Move cab back to transport position. Ensure cab pin (36) is fully seated in frame right front transport receptacle (35) and
ensure receptacle does not move.
12.
Tap transport receptacle (35) in place around frame pin (36). Keep U-shaped receptacle slot level and center pin in slot.
13.
Slowly move cab back to operational position to access adjusted receptacle (35).
14.
Tighten receptacle bolts (37) and nuts (39) to 180 lb-ft (244 Nm).
NOTE
A stiff wire (approximately 3 ft (0.91 m) long with a 2-in. (5.08-cm) right angle bend) may aid in ensur-
ing frame pins are fully seated in right transport receptacles.
36
36
35
35
37,38 (HIDDEN)
37,38
434-40122
434-40121
15.
Move cab to operational position.
16.
Remove and discard two nuts (41) and washers (42) from receptacles (40).
17.
Install two new nuts (41) and washers (42) and tighten bolts enough to allow for adjustment.
18.
Move cab back to transport position. Ensure cab is fully seated in right-side transport receptacles (35).
19.
Tap left-side transport receptacles in place to receive cab pins (11). Ensure the receptacles are parallel and as level as
possible.
20.
Insert cab pin (11) in hole to center receptacles.
21.
Tighten receptacle bolts (43) and nuts (41) to 180 lb-ft (244 Nm).
22.
Remove cab pins (11).
0138 00-10
