TM 10-3930-675-24-2
CAB TRANSPORT LIFT MAINTENANCE - CONTINUED
0138 00
CAB ADJUSTMENT: OPERATIONAL POSITION - CONTINUED
12.
Move cab slowly back to operational position. Operate cab side movement control until right rear pin (20) is seated in
receptacle (23) and until cab stops.
13.
Tap right front receptacle in place around frame pin (20).
14.
Keep U-shaped receptacle slot level and center pin (20) in slot.
15.
Raise cab lift transport and move cab to transport position to access adjusted receptacle (23). Tighten two receptacle
bolts (22) and nuts (21) to 180 lb-ft (244 Nm).
16.
Move cab back and forth several times and check adjustments of two right receptacles to cab maintains 4-9/19-in. gap.
Cab should stop at same position each time, and receptacles should not move when pins are fully seated or until cab
stops.
20
21
23
22
434-40114
17.
Move cab to transport position. Remove and discard two nuts (25) and washers (26) on two left, front, and rear recepta-
cles (24).
18.
Install two new nuts (25) and washers (26) and tighten bolts (27) just enough to allow for adjustment.
19.
Move cab back to operational position and ensure cab is fully seated in right-side receptacles.
25,26
24
27
25,26
24
27
434-40116
434-40115
0138 00-6