TM 10-3930-675-24-2
CAB TRANSPORT LIFT MAINTENANCE - CONTINUED
0138 00
CAB TRANSPORT SYSTEM INSPECTION - CONTINUED
8.
Check for cab transport lift height alignment.
a.
If cab transport lift height is not aligned, adjust cab lifting cylinder height (WP 0173 00). Properly support cab lift
transport and remove pin (5) from cylinder clevis (6) to lower cylinder (7). Loosen jamnut (8) below clevis and
turn clevis to adjust height alignment of wear plates (9).
5,6,7,8
434-4106
9 (HIDDEN)
If cab lift transport and cab support frame (4) are not aligned, check cab lift transport for worn plates (refer to Cab
b.
Lift Structure Removal). Raise cab lift transport and check gap between cab lift transport and cab support frame.
Maximum allowable gap is 0.75 in. (19 mm) as shown.
9.
Move cab to transport position (TM 10-3930-675-10).
10.
Loosen four bolts (10) on cab support frame (4) and make small alignment adjustments.
11.
Tighten four cab support frame bolts (10).
12.
Move cab back and forth several times to check for proper operation.
TOP STEP
4
GAP
10
10
434-40109
434-40110
0138 00-3
