TM 10-3930-675-24-2
TOPHANDLER WEAR PLATES REPLACEMENT - CONTINUED
0147 00
STYLE A WEAR PLATE REMOVAL - CONTINUED
6
6
5
3
3.
Measure wear plate thickness. Measurement MUST be a minimum of 1 in. (25.4 mm). If wear plate is not as specified,
replace wear plate.
STYLE A WEAR PLATE INSTALLATION
1.
Measure thickness of shims (6) removed from wear plate location. Shim measurement MUST NOT exceed 0.25 in. (6.4
mm). Remove shims as necessary so as not to exceed requirement.
NOTE
Total thickness of wear plate and shims for style A location must not exceed 1.25 in. (31.8 mm).
2.
Install wear plate (5) and shims (6) as needed in sliding carriage frame (4).
Position cover (3) and secure in place with six screws (1) and washers (2). Tighten screws in accordance with Torque
3.
4.
Perform operational check of tophandler (TM-10-3930-675-10).
0147 00-5
