TM 10-3930-675-24-2
TOPHANDLER WEAR PLATES REPLACEMENT - CONTINUED
0147 00
STYLE B WEAR PLATE REMOVAL - CONTINUED
3.
To access a style B wear plate on sliding beam interior:
NOTE
Internal beam wear plates may use a spacer block in some mounting locations. Ensure spacer block is
retained and replaced.
a.
Remove ten screws (19), washers (20), and two access panels (21 and 22) from side of each extending beam.
21
19,20
22
b.
With assistance, extend or retract beams to expose internal-mounted style B wear plates (TM 10-3930-675-10).
c.
Position tophandler beams on cribbing to aid in relieving weight from load-bearing wear plates.
d.
Perform procedures in step 1 to remove wear plate, frame, backing plate, and mounting plate.
STYLE B WEAR PLATE INSTALLATION
1.
To install a style B wear plate mounted on sideshift carriage frame:
a.
Position wear plate (14), frame (15), spacer (13), and spacer (12) on sideshift carriage frame (9).
b.
Align and install screw (7) and washer (8) to secure wear plate (14) in position on sideshift carriage frame (9).
Hand-tighten screw.
c.
Align holes in mounting plate (12) with sideshift carriage frame (9) and install four screws (10) and washers (11).
d.
e.
Perform operational check of tophandler (TM-10-3930-675-10).
0147 00-8
