TM 10-3930-675-24-2
TOPHANDLER WEAR PLATES REPLACEMENT - CONTINUED
0147 00
STYLE D WEAR PLATE REMOVAL
NOTE
If measurement of wear plate is less 0.5 in. (12.7 mm), perform this procedure to replace wear
plate.
Note location of beveled edge on wear plate. Ensure wear plate is oriented with beveled edge in
same position for installation.
1.
Position sliding beam to access wear plate (31) and remove two screws (36) and lock plate (33).
2.
Through access hole in extending beam, remove two screws (34) and washers (35) securing wear plate (31) and shims
(32).
3.
Slide two wear plates (31) and shims (32) from extending beam location.
33
32
31
31
32
36
34,35
STYLE D WEAR PLATE INSTALLATION
NOTE
Ensure wear plates are oriented with beveled edge the same as noted in removal.
1.
Position two wear plates (31) on extending beam.
2.
Install two screws (34) and washers (35) through access hole in extending beam to secure wear plates (31).
3.
Position lock plate (33) on extending beam.
4.
Install two screws (36) to secure lock plate (33).
5.
6.
Perform operational check of tophandler (TM-10-3930-675-10).
0147 00-12
