TM 10-3930-675-24-2
TOPHANDLER WEAR PLATES REPLACEMENT - CONTINUED
0147 00
STYLE B WEAR PLATE INSTALLATION - CONTINUED
3.
To install a style B wear plate on sliding beam interior:
NOTE
Ensure spacer blocks are replaced with sliding beam internal wear plates where used.
a.
Perform procedures in step 1.
b.
Position two access panels (21 and 22). Install and tighten ten screws (19) and washers (20).
21
19,20
22
STYLE C WEAR PLATE REMOVAL
NOTE
If measurement of wear plate is less 0.5 in. (12.7 mm), perform this procedure to replace wear
plate.
To prevent shifting of sideshift carriage, wear plates should be replaced in sets one at a time.
1.
With assistance, position sideshift carriage (24) on cribbing to relieve weight on wear plates (23).
2.
Remove two screws (28), washers (29), and nuts (30) securing lock plate (25) in position. Remove lock plate and retain
for installation.
3.
Through access hole in frame bottom, remove screw (26) and washer (27) securing wear plate (23) to sideshift carriage
frame (4).
4.
Slide wear plate (23) from position on sideshift carriage frame (4).
0147 00-10