TM 10-3930-675-24-2
CAB LIFTING CYLINDER REPLACEMENT - CONTINUED
0173 00
REMOVAL
1.
Raise cab lifting cylinders to fully raised position (TM 10-3930-675-10).
2.
Place wood cribbing under cab transport lift (3) to hold cab transport lift in raised position.
3.
4.
5.
Disconnect two hydraulic hoses (9) from cylinder (4). Cap/plug both hydraulic hoses. Remove and discard O-rings.
6.
Remove pin (2) from top of cylinder (4).
7.
Remove screw (7), washer (6), and cotter pin (5) from bottom of cylinder (4). Discard cotter pin.
8.
Lift cab transport lift (3) to remove cylinder (4) from mounting brackets (1 and 8).
1
2
3
4
9
5
8
6
7
INSTALLATION
NOTE
Refer to General Maintenance Instructions (WP 0284 00) for complete instructions on connecting
hydraulic hoses and applying proper torque.
1.
Lift cab transport lift (3) and align cylinder (4) to mounting brackets (1 and 8).
2.
Install new cotter pin (5), washer (6), and screw (7) on bottom of cylinder (4).
3.
Apply a thin coat of grease to pin (2). Install pin in top of cylinder (4).
0173 00-2