TM 10-3930-675-24-2
HYDRAULIC SYSTEM TEST POINT PROCEDURES
THIS WORK PACKAGE COVERS
General
Test Point No. 7: Steering Pump No. 2
Test Point No. 8: Boom Lift and Extend Main Valve
Test Point No. 1: Brake Accumulator No. 1
Test Point No. 9: Servo System
Test Point No. 2: Brake Accumulator No. 2
Test Point No. 10: Cab Lift Main Valve
Test Point No. 3: Steering System Main Valve
Test Point No. 11: Tophandler and Boom Folding Sys-
Test Point No. 4: Brake Circuit No. 2
tems
Test Point No. 5: Brake Circuit No. 1
Test Point No. 12: Engine Driven Pump/Fan Hydraulic
System
Test Point No. 6: Steering Pump No. 1
INITIAL SETUP
Maintenance Level
Materials/Parts
Organizational
Personnel Required
Tools and Special Tools
Two
Tool Kit, General Mechanic's (Item 128, WP 0289
References
Equipment Condition
Gage, Pressure, Multiple Dial Indicating (Item 44,
Parking brake applied (TM 10-3930-675-10)
Engine shut down (TM 10-3930-675-10)
Wheels chocked
WARNING
DO NOT disconnect or remove any hydraulic system line or fitting unless hydraulic system pres-
sure has been relieved. Tighten all connections before applying pressure. Escaping hydraulic fluid
under pressure can penetrate the skin, causing serious injury.
Search for leaks with a piece of cardboard. Protect hands and body from high-pressure fluids. If
an accident occurs, see a doctor immediately. Any fluid injected into the skin must be surgically
removed within a few hours or gangrene may result.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting
any hydraulic lines. Failure to do so could result in injury.
Hydraulic fluid is very slippery. Immediately wipe up any spills. Failure to follow this warning
may result in injury to personnel.
CAUTION
Wipe area clean around all hydraulic connections prior to disconnecting. Cap or plug all openings
after disconnecting. Contamination of hydraulic system could result in equipment failure.