TM 10-3930-675-24-2
TOPHANDLER REPLACEMENT - CONTINUED
0189 00
REMOVAL - CONTINUED
CAUTION
Damage to boom support and frame slide bearings can occur if the boom support locking pins are
extended or retracted into the operational/locked position when the tophandler is removed from the
boom.
6.
Lower tophandler onto cribbing on deck of trailer until oscillation/leveling cylinders are fully collapsed (TM 10-3930-
675-10). Raise boom just enough to start lifting collapsed center section .04 in. (1 mm) or less off center wear pads
(2).
2
434-40057
WARNING
DO NOT fully relax the boom pressure on the tophandler. Serious injury or damage can occur from
boom movement during pivot shaft removal.
7.
Shut down RTCH engine.
NOTE
DO NOT disconnect tophandler angle sensor from junction box.
8.
Remove tophandler angle sensor/bracket (3) and cable clamps from their mounting, move aside and secure to boom,
3
434-40058
0189 00-3