TM 10-3930-675-24-2
CYLINDER HEAD REPLACEMENT - CONTINUED
0199 00
INSPECTION - CONTINUED
8.
Inspect push rods (13) and push tubes (14) for excessive or uneven wear and bending. If push rod or tube is bent, shows
excessive wear, or is filled with oil, it must be replaced.
13
14
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during
procedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep
clear of heavy parts supported only by lifting device. Failure to follow this warning may result in
death or injury to personnel.
CAUTION
DO NOT drop cylinder head on gasket. Gasket material can be damaged.
NOTE
Ensure shipping plug and plastic insert are removed from fuel inlet and fuel drain passage. If plastic
insert is not removed from passage of fuel inlet line connection, engine will not start.
0199 00-11