TM 10-3930-675-24-2
OIL FILTER HEAD AND OIL COOLER MAINTENANCE - CONTINUED
0209 00
ASSEMBLY - CONTINUED
2.
Install bypass valve plunger (16), spring (17), and washer (18) in oil filter head (3) and secure with retaining ring (19).
3
19
16
17
18
INSTALLATION
1.
With assistance, position oil filter head (3) with new gasket (9) on engine.
2.
Secure oil filter head (3) with six washers (11) and screws (10). Tighten screws to 35 lb-ft (47 Nm).
9
3
11
10
3.
Lubricate two new O-rings (13) with clean engine oil and install on oil cooler inlet and outlet tubes.
NOTE
Ensure seal retainer flat sides are facing each other when inserted into seal retainer.
4.
Place seal retainer (6) on oil cooler (7) and insert, as far as possible, two seal retainers (12).
5.
Lubricate two new O-rings (8) with clean engine oil and insert into seal retainers (12).
6.
Position new gaskets (15) on oil filter head (3).
7.
Install oil cooler (7) into thermostat housing and on oil filter head (3). Secure oil cooler to oil filter head with four
screws (14). Tighten screws to 35 lb-ft (47 Nm).
0209 00-8