TM 10-3930-675-24-2
ACCESSORY DRIVE ASSEMBLY MAINTENANCE - CONTINUED
0213 00
INSPECTION - CONTINUED
4.
Measure driveshaft journals at four points indicated. Measurement must be as indicated. If driveshaft journals are not
within standard, replace shaft.
a.
Point 1: 1.3773 to 1.3779 in. (34.984 to 35.000 mm)
b.
Point 2: 1.7706 to 1.7716 in. (44.975 to 45.000 mm)
c.
Point 3: 1.8772 to 1.8728 in. (47.554 to 47.570 mm)
d.
Point 4: 1.0030 to 1.0035 in. (25.476 to 25.489 mm)
1
2
3
4
DRIVE SHAFT JOURNALS
5.
Measure inside diameter of drive gear. Measurement must be 1.8694 to 1.8704 in. (47.484 to 47.509 mm). If diameter is
not within standard, replace drive gear.
DRIVE GEAR INSIDE DIAMETER
0213 00-8
