TM 10-3930-675-24-2
TRANSMISSION ASSEMBLY REPLACEMENT - CONTINUED
0224 00
REMOVAL - CONTINUED
15.
Remove four screws (14) and washers (15) securing transmission to mounting brackets (16 and 17).
FRONT
16
17
14,15
14,15
RIGHT SIDE
LEFT SIDE
NOTE
Transmission must be moved toward rear, away from engine a minimum of 3 inches, while keeping
perfect alignment to avoid major damage to the flywheel and to allow damper plate guide stud to clear
the flywheel housing.
16.
Separate transmission from engine and use nylon sling to ensure damper plates and torque converter remain with trans-
mission.
17.
Lift transmission from vehicle and place on temporary cribbing.
NOTE
Perform steps 18 thru 21 only if a replacement transmission is to be installed.
18.
Remove and retain damper plates and torque converter (WP 0223 00).
19.
Remove and retain these sensors (WP 0096 00):
a.
Gearbox temperature sensor
b.
Output speed sensor
c.
Engine speed sensor
d.
2WD/4WD sensor
e.
Turbine speed sensor
f.
Internal gear speed sensor
0224 00-8
