TM 10-3930-675-24-2
FRONT AXLE ASSEMBLY REPLACEMENT - CONTINUED
0227 00
REMOVAL
NOTE
Blocking both sides of rear axle will prevent vehicle from tilting when front of vehicle is raised.
1.
Block left and right sides of rear axle between axle and axle stops.
2.
Place two hydraulic jacks under front axle (1) as shown. Raise jacks to contact bottom of axle and lift.
3.
Place wood blocks under front of vehicle frame (2) close to hydraulic jacks. Lower jacks and support frame on wood
blocks.
2
1
434-40084
4.
Repeat steps 2 and 3 on opposite side of front axle.
5.
6.
NOTE
Axle must be removed with all local connecting lines, fittings, and assorted parts intact.
7.
Trace main hydraulic supply and return lines (3) to junction box (4), located above axle center section. Disconnect and
cap lines and fittings from junction box.
8.
Disconnect breather line (5) from top of axle (6) center section.
9.
Remove and cap parking brake hydraulic pressure line (7).
10.
Disconnect wheel temperature sensor at connector on left end of axle (WP 0093 00).
11.
Remove steering system wheel sensors (WP 0104 00, steps 1 thru 3 and NOTE). Hang sensors on main frame.
0227 00-2