TM 10-3930-675-24-2
FRONT AXLE ASSEMBLY REPLACEMENT - CONTINUED
0227 00
INSTALLATION - CONTINUED
11.
12.
13.
14.
15.
Install a jumper between pins of the wheel temperature sensor connector, at the connector end attached to the vehicle
wiring harness (WP 0093 00). This will allow filling of the wheel cooling areas and will be removed and the sensor con-
nected normally later.
16.
17.
Fill front axle differential (WP 0050 00) and check for leaks.
18.
19.
Start engine and bring hydraulic oil temperature to 150F.
20.
21.
Operate machine 100 feet forward and then 100 feet in reverse, 10 times at a speed of no greater than 5 mph.
22.
When step 21 is completed, stop the machine and remove the jumper between pins of the wheel temperature sensor con-
nector and connect the sensor to the wiring harness. Check for leaks and recheck oil levels in axle.
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE
0227 00-7/(0227 00-8 Blank)