TM 10-3930-675-24-2
REAR AXLE ASSEMBLY REPLACEMENT - CONTINUED
0228 00
INSTALLATION - CONTINUED
12.
For USMC vehicle, install the autolube junction boxes and local connecting lines that supply the rear wheel spindle area
components and steering cylinder pivot point.
13.
14.
15.
16.
17.
18.
19.
Return cab and boom support to operational position (TM 10-3930-675-10).
20.
21.
22.
Fill rear axle differential. Check and/or fill hub end of new axle (WP 0050 00).
23.
Remove blocks from front wheels.
24.
25.
Install a jumper between pins of the wheel temperature sensor connector, at the connector end attached to the vehicle
wiring harness (WP 0093 00). This will allow filling of the wheel cooling areas and will be removed and the sensor con-
nected normally later.
26.
Start engine and bring hydraulic oil temperature to 150F.
27.
28.
Operate machine 100 feet forward and then 100 feet in reverse, 10 times at a speed of no greater than 5 mph.
29.
When step 28 is completed, stop the machine and remove the jumper between pins of the wheel temperature sensor con-
nector and connect the sensor to the wiring harness. Check for leaks and recheck oil levels in axle.
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE
0228 00-5/(0228 00-6 Blank)