TM 10-3930-675-24-2
FORKLIFT CYLINDER REPLACEMENT - CONTINUED
0261 00
REMOVAL
1.
Loosen nylon strap (10) and disconnect two hydraulic hoses (2) from adapter fittings (1).
2.
Remove two adapter fittings (1) from cylinder (9).
3.
At one end of cylinder (9), remove screw (4) and spring washer (5).
4.
Remove pin (6).
5.
If damaged, remove two retaining rings (7) and guide bearing (8).
6.
Repeat steps 3 thru 5 for opposite end of cylinder (9).
7.
Remove cylinder (9) from forklift frame (3).
2
4,5
2
1
3
6
7,8
10
9
INSTALLATION
NOTE
Refer to General Maintenance Instructions in WP 0284 00 for complete instructions on connecting
hydraulic hoses and applying proper torque.
1.
If removed, install guide bearing (8) and two retaining rings (7).
2.
Position cylinder (9) on forklift frame (3) and install pin (6).
3.
Install spring washer (5) and screw (4).
4.
Repeat steps 1 thru 3 for opposite end of cylinder (9).
5.
Install two adapter fittings (1) on cylinder (9).
6.
Connect two hydraulic hoses (2) to cylinder (9). Tighten nylon strap (10).
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE
0261 00-2