TM 10-3930-675-24-2
HYDRAULIC RESERVOIR REPLACEMENT - CONTINUED
0262 00
REMOVAL - CONTINUED
NOTE
If vehicle is equipped with arctic heater, perform steps 5 thru 7. If vehicle is not equipped with arctic
heater, proceed to step 8.
5.
Remove two screws (11), washers (12), and arctic heater electrical and fuel lines (15) with support from hydraulic reser-
voir (4).
6.
Remove screw (24) and hose clamp (25). Cut and discard tiedown straps as necessary.
7.
Position arctic heater electrical and fuel lines (15) away from hydraulic reservoir (4).
8.
At top left side of reservoir (4), disconnect hydraulic oil return hoses as follows:
a.
Remove four screws (16), flange (17), and O-ring (18) to disconnect each of five hoses (21). Discard O-rings.
b.
Disconnect ten remaining hoses (20) from fittings (19) at reservoir.
9.
Remove four screws (13), flange (14), and sensor (22) with electrical lead (23) from hydraulic reservoir (4).
14 15 16 17,18
19
4
11,12
13
20
25
24
19
19
20
21
23 22
21
20
0262 00-4